BENDIX GEN 4 GEN 5 ABS Návod k obsluze stáhnout pdf (Strana 22)

16 NEXIQ Brake-Link™ Bendix

& Eaton

ABS Applications

Chapter

• Establishing Connection

Connecting Brake-Link™ Components

Connect Brake-Link™ to the vehicle with one of the following adapters:

• J560 PLC Cable Set. Attach to the tractor or trailer J560 Power Line

Connector. Note:

The ECU must be configured to support Enhanced

PLC Mode in order to use this adapter.

• 9-Pin Deutsch. Attach to the Deutsch Connector typically located under

the dash (driver’s side), beside the driver’s seat or near the trailer brake

ECU.

Choosing the appropriate adapter depends on:

• whether you’re diagnosing the Tractor or Trailer;

• which connectors are available on the Tractor/Trailer;

• whether the Tractor is connected to the Trailer;

• whether the ECU is configured to support

Enhanced PLC Mode

Do you know what Enhanced PLC Mode is?

Older brake ECUs transmit diagnostic information over the J1708 Bus only

(Figure 2.3, page 19)—accessing both tractor and trailer ECUs requires

independent connections. Newer ECUs offer Enhanced PLC Mode—they

can send diagnostic information over the power line. If the tractor and

trailer are connected, access both ECUs via a single connection.

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 111 112

Žádné komentáře

BENDIX GEN 4 GEN 5 ABS Návod k obsluze Strana 22