BENDIX BW2262 Uživatelský manuál stáhnout pdf (Strana 14)

FIGURE 15 - Speed Sensor Installation

Friction Sleeve

Sensor

ABS

Sensor

Bushing

Sensor

Push

FIGURE 16 - Wheel Speed Sensor Components

Installation

Installation of the Bendix

A-18

™

trailer ABS system is similar

from one configuration to another. All systems use the same

speed sensors and valves. The differences are in

placement and quantity and the type of ECU, either standard

or basic. Refer to the following general component

instructions and to the wiring and plumbing diagrams for

specific system configuration.

Suggested Order Of Installation

Following is a suggested order of installation of the A-18

™

trailer ABS.

1. Install Wheel Speed Sensors (often part of a dressed

axle).

2. Install Relay Valve(s)/ECU assembly.

3. Install the Power Cable, but do not apply power until

the installation is complete.

4. Route and connect the main ABS Harness.

5. Install the Diagnostic Port Connector.

6. Install the trailer-mounted ABS Warning Lamp.

7. Perform the End-of-Line Checkout.

Install the Wheel Speed Sensors and Sensor

Friction Sleeves

Refer to the appropriate diagram for your system and locate

the wheel speed sensors. Refer to Figures 23-26.

1. Install the sensor friction sleeve with the flange stops

towards the inboard side of the vehicle.

2. Apply high-temperature silicon-based grease to the

body of the speed sensor.

3. Push the speed sensor completely into sensor friction

sleeve by hand until it stops against the tone ring. The

speed sensor is properly installed and adjusted when it

is touching the tone ring. Allowable TIR for the tone

ring is 0.008 inches.

NOTE: The speed sensor must be able to slide freely in

and out of the sensor friction sleeve bore. Operating the

vehicle with seized components will damage the speed

sensor and the tone ring.

4. Route the cable to the frame. Use tie wraps as required

to restrain cable. Use care not to stress sensor cables.

5. Connect sensor cable to harness and install fasteners

to hold the sensor cable in position.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 39 40

Komentáře k této Příručce

Žádné komentáře

BENDIX BW2262 Uživatelský manuál Strana 14

Komentáře k této Příručce

Související produkty a manuály pro Modulátor BENDIX BW2262