BENDIX BW2262 Uživatelský manuál stáhnout pdf (Strana 16)

ECU/

Modulator

Valve

Power

Cable

ECU Side

Trailer

Side

Nose

Box

FIGURE 19 - Inline Power Connector

ABS ABS

5 Pin

Weatherpack

One Bayonett Connector

at Relay Valve

Diagnostic

Male

Bayonet

Warning

Light

Chassis

Ground

J560

6" Pigtail

Two

Speed

Sensors

Road SideRoad Side

5 Pin

Weatherpack

Deutsch

Hd-10

Diagnostic

Bayonett Connector

at Relay Valve

(Up to 2)

Male

Bayonet

Warning

Light

Chassis

Ground

J560

6" Pigtail

Speed

Sensor

(2 or 4)

BASICSTANDARD

FIGURE 20 - Standard and Basic ABS Harnesses

Install the Inline Power Connector

The inline power connector is on the end of the main ABS

harness and connects the ABS system to the trailer

electrical system.

Install the Main ABS Harness

1. Remove power from the trailer.

2. Unlock the ECU cover and remove.

3. Install the ECU connectors as follows:

Standard: Plug the grey harness connector into the

ECU connector labeled “X1”. The connector is keyed

and can only fit in one direction. Plug the black harness

connector into the ECU connector labeled “X2”. This

connector is also keyed.

Basic: Plug the green harness connector into the ECU

connector labeled “X1”. This connector is also keyed

and is the only connector on the ECU.

4. Install the ECU cover by first engaging the alignment

tabs and then hinging the cover closed, ensuring that

the convoluted tubing is captured in the strain relief slots.

Slide the cover lock to the locked position. An optional

tie wrap may be used to lock the cover in place.

5. Route harness to designated locations. Make sure that

the harness is properly routed and secured to prevent

damage to the harness.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 39 40

Komentáře k této Příručce

Žádné komentáře

BENDIX BW2262 Uživatelský manuál Strana 16

Komentáře k této Příručce

Související produkty a manuály pro Modulátor BENDIX BW2262